@GQ
1 days ago
26

Hi everyone, new here, - not new to mining, new to mining with an ASIC.

Just received my LV08 from MF on Ali, configured it according to instructions and video, connected to my wifi, set it up with PublicPool, - all good so far, but only getting about 2.6TH/s at 80W or so. Messed with the few settings there are, not much different. Have tried plugging it into different outlets, all the same. Have just noticed that the ASIC voltage request is 1.2V but the measured is 0 (zero). Nothing I do seems to affect that or getting the unit to draw more than about 80W except at boot, sometimes it will show a spike in voltage/hashrate for a few seconds, then back down to 2.5-2.6 or so and again, zero ASIC voltage measured. Also, i keep reading about a green light somewhere on the unit, but if I look inside, I see a red light glowing steady. Am I SOL here? Help?

4
Sign in You can only post comments after logging in.
@bernd2

hi, ive the same miner LV06 to 08 and avalon nano and mini.

i set the Frequency to 575 MHz and the Core Voltage of 1250mV,

so the iner make aprox 4.3THs at 121Watt of power.


80Watt ist the noirmal power consumtion at standat frequenc

1250







@GQ

Thank you for the response, - is it ok to see ( (zero) ASIC voltage measured? Any help would be appreciated. Just want to make sure my unit isn't faulty.

@bernd2

no my LV08 shows always a masured voltage.

please take a look into the "Logs" - "Realtime Logs" there is the voltage shown as a textline. if theres a vboltage to seen maybe the firmaware have a malfunktion or you look with firefox-browser. with firefox ive a big problem to see the correct result. i still use chrome. theres the best.

@GQ

ok thank you. Good note, - I'm on firefox here.

Active Users
43 participate in
37 participate in
34 participate in
18 participate in
3 participate in
2 participate in
2022 Minerfixes - All Rights Reserved