Reset scheme one

1. Turn off the router (the device cannot connect to the memorized WiFi);

2. Connect to the device WiFi (Lucky_****) through mobile phone or computer;

3. Change the WiFi name on the device configuration page (modify the memory);

4. Save and restart;

5. Start the router and reconfigure.

Reset scheme two

1. Move the device outside the coverage of the original WiFi signal (cut off the connection);

2. Connect to the device WiFi (Lucky_****) through mobile phone or computer;

3. Change the WiFi name on the device configuration page (modify the memory);

4. Save and restart;

5. Return to the coverage of the original WiFi signal and reconfigure.

https://www.zeusbtc.com/articles/asic-miner-troubleshooting/5465-lucky-miner-lv07-lv06-lv05-troubleshooting-tutorial

My LV06 shows Device Overheating, how do i fix it?

After updating, it worked for about 2 days, now it's not working

Power Consumption:0.01 W

Hash Rate:0.00 Gh/s

Logs, have too many lines

bm1366Module: Serial RX invalid 11

after about 100 lines with the same message another round with a different message appeared

" ₿ (521548) asic_result: Nonce difficulty 0.00 of 10000."

i tried soft restart and hard reset with no luck, still the same

Worked easily

It was an easy guide, thank you

na verdade esta falhando ao atualizar

não tem a opção de carregar o arquivo parece que faz de forma automática agora

Is it possible to roll back the update?

when 2.4.0 firmware planed?

Vraag. kan je met de luckyminer v6 ook in pools zoals 2miners en zo ja hoe doe je dat dan? Ik Ik aagje. VR-een

Hello everyone, thank you for providing the firmware. I have a question about the 2.3.0 firmware. Flashing worked without any problems. Mining in the solo pool also works - now I wanted to make changes to the settings, but the save button cannot be pressed. Does anyone know this? Is there a solution for this?

Greetings

opconne

Is there a way to add an external antenna to the LV06? Is there a schematic you can post?

in version 2.3.5, the miner was constantly disconnected, I had to go back to version 2.3. Why does the miner turn off all the time? Even after the update, it restarts exactly 2-10 minutes later. It doesn't work smoothly!!!

How do I upgrade the firmware? Can someone please post step by step instructions. Thanks in advance.

After the update I see AxeOS Recovery what can I do now?