S9k the chips 40~50 with low hashrate,what's the problem?
To understand the initial problem, it is possible that the repalced chip are not compatible with the original chips. It is important to
2023-07-10 01:03
304
0
The 3rd hashboard has no hashrate
RE:Do single-board test on the 3rd hashboard to verify the issue.
2023-07-08 12:24
325
0
T9+ board 12V is abnormal, clamp points lower than 2.8V.
T9+ board 12V is abnormal, clamp points lower than 2.8V.And the last five voltage domains only have 1.5V.Response: The clamp circuit for
2023-07-08 09:37
363
0
S9 hashboard can get 12V and domain voltage 9V when data cable unplug, but no 9V when plug in
Re:Verify if there is short circuit at 3.3V, check the capacitor short circuit.
2023-07-08 09:17
314
0
S9K control board issue,C43 control board SD card flashing fail
S9K control board issue,C43 control board SD card flashing fail as the picture showes,Re:SD card flash the V9 file, if the IP address ca
2023-07-08 08:49
401
0
L3+ single-board teste-- temperature error
L3+ single-board teste-- temperature error as the below picture shows,Re:The temp sensor model in test file configuration does not match
2023-07-08 08:44
397
0
After flashing the PIC on the T17 hashboard, the machine is unable to run the hashrate. What could be the issue?
After flashing the PIC on the T17 hashboard, the machine is unable to run the hashrate. What could be the issue?Re:When encountering an
2023-07-08 08:23
284
0
S9i hashboard, sometimes pass the single-board test, sometimes report 0.
S9i hashboard, sometimes pass the single-board test, sometimes report 0.Whenever it reports a 0, simply measuring the voltage at the IO
2023-07-08 08:17
305
0
S9 hashboard single -board test resulted a long string of code, the device hashrate dropped.
S9 hashboard single -board test resulted a long string of code as above picture, the device hashrate dropped.Reply:Replace chip 62.
2023-07-08 08:09
301
0
2022 Minerfixes - All Rights Reserved